Skip to main content
Moen Solutions

How do I disable or re-enable the sensors?

  1. Last updated
  2. Save as PDF

 

Verify your faucet by identifying the control box under your sink

Snag_f7409e9.png

To disable both sensors: Hold your hand directly above the wave sensor for approximately five (5) seconds. Water will begin to run and then turn off, indicating MotionSense Hands-Free has been disabled.
To disable Ready Sensor only: Open handle, hold hand above wave sensor for 5 seconds. 
To enable the Ready Sensor, repeat the same process.
Note: If you have received a service electronic box, follow instructions listed for our new MotionSense faucet: or click here for the instruction sheet.

Snag_f74236c.png

To disable the Ready Sensor (front), turn on the water with the handle and hold your hands in front of both sensors for five seconds -- remove your hands after you see one blue light flash on the Ready Sensor (front). To disable both sensors, hold your hands in front of both sensors for 10 seconds until you see a blue light flash twice on the Ready Sensor (front) Move your hands away and turn off the water. To re-enable the sensors, simply perform these actions again.