Skip to main content
Moen Solutions

Kitchen Handle: Integra Model 87315 and 67315

Moen produces a variety of Top Handle with Pullout Sprayer faucets. The interior components and assembly are not the same for each model.  This mechanism is designed specifically for Integra 87315 and 67315  faucets built prior to 2009. This faucet utilizes a 1225 cartridge.




integra breakdown.png


  1. Carefully pull the plug button (#1) out of the handle (#3).
  2. Unthread the set screw (#2) from the hole on the front of the handle (#3). Remove handle.
  3. Using a Phillips screwdriver, remove the Phillips screw (#4).
  4. Lift the adapter/connector (#5) off.
  5. Being careful not to damage the finish, unscrew and remove collar (#6) and lift off pivot retainer (#7).
  6. Unscrew and remove retainer nut, o-ring, bearing washer and washer(s) (#8).

To replace the cartridge see article 1225 Cartridge: Kitchen Faucet.


  1. Re-install pivot retainer (#8) with exterior horizontal grooves facing the back of the faucet.
  2. Replace the collar (#6) and hand tighten.
  3. Hook the lug on the adapter/connector (#5) into the groove on the pivot retainer (#7). 

    adapter connector.png

    handle lug.png

  4. Screw in and tighten the Phillips screw (#2) and place the handle (#3) back on the faucet assembly.
  5. Thread the set screw (#2) back in the handle (#3) and push the plug button (#1) back in the hole on the handle (#3).

For additional information on Moen products visit and select the type of product you are repairing. The guide will contain repair details, troubleshooting and specific information on assembling handles associated with that style of product.

Still Not Finding What You're Looking For?

Contact Us or Call 1-800-BUY-MOEN           

Non US?  Moen Canada | Other International Sites  

  • Was this article helpful?