Kitchen Handle Motionsense Wave: Slide On Dome

Notes:

*In some cases, accessing the hole in the handle might require loosening the faucet under the sink and rotating the body of the faucet.

*Some models may have a small round plug/cap covering the handle hole which will need to be removed before using the 3/32" Hex wrench.

Disassembly

1. Insert a 3/32" Hex wrench into the hole in the handle (#2) and unthread the set screw (#1) counter-clockwise to loosen it until the handle (#2) can slide off. It is not recommended to remove the screw.
2. Rotate the handle hub (#3) 90 degrees and pull it off the faucet.

2. Align the two recessed cutouts on the inside of the handle hub (#3) with the two plastic tabs on the white ring and slide the handle hub (#3) onto the valve body. Next, rotate the handle hub (#3) 90-degrees. Ensure that the oblong opening in the handle hub (#3) is pointing downwards after the 90-degree rotation.

3. Slide the handle (#2) onto the stem of the cartridge. Using a 3/32" Hex wrench, tighten the set screw (#1). Note: If you loosened the mounting hardware under the sink to rotate the faucet to gain access to the set screw, rotate the faucet back to the original position and tighten the mounting hardware.

The following is a critical process, You must perform these steps in order for your faucet to function properly: 

1. Open the handle to the full on position.
2. Rotate the handle back until it stops for full hot.
3. Rotate the handle forward until it stops for full cold.
4. Turn the handle off.