Kitchen Handle Motionsense Wave: Threaded Dome

Disassembly:

In some cases, accessing the hole in the handle might require loosening the faucet under the sink and rotating the body of the faucet.

1. Removed small round plug/cap (#1) covering the handle hole. (Not used in all faucets).

2.  Using a 3/32" Hex wrench, loosen the set screw (#2) until the handle (#3) lifts off. Slide the handle (#3) off of the faucet.

3.  Unscrew the handle hub (#4) to remove.

Assembly:

1. Screw the handle hub (#4) back on to the faucet.

2. Slide the handle (#3) back on and tighten the set screw (#2) to complete installation.

3. If applicable, replace the small round plug/cap (#1).

If you loosened the mounting hardware under the sink to rotate the faucet to gain access to the set screw, rotate the faucet back to the original position and tighten the mounting hardware.

The following is a critical process, You must perform these steps in order for your faucet to function properly: 

1. Open the handle to the full on position.
2. Rotate the handle back until it stops for full hot.
3. Rotate the handle forward until it stops for full cold.
4. Turn the handle off.