Shower Handle: Moentrol with Integrated Transfer Valve- Handle Type A

Disassembly:

1. Gently pry the cap (#1A) off of the end of the handle (#3A).

2. Using a Phillips screwdriver, unthread the handle screw (#2A) counter-clockwise and remove the handle (#3A).

3. Slide the spacer (#4A) off the assembly.

To replace the cartridge (#5A), see article 1200, 116719 and 162154 Cartridge: Moentrol with Integrated Transfer Valve.

Assembly:

1. Confirm that the cartridge clip is installed and use pliers to pull the brass stem of the cartridge (#5A) outward.

2. Rotate the stem of the cartridge (#5A) so the two flat sides of the brass stem are facing to the left and right.

3. Slide the spacer (#4A) onto the assembly.

4. Position the handle (#3A) with the lever facing down, slide the handle (#3A) onto the assembly and use a Phillips screwdriver to thread the handle screw (#2A) clockwise until tight.

5. Push the cap (#1A) back into the handle (#3A). 

Disassembly:

1. Gently pry the cap (#1B) off of the end of the handle (#3B).

2. Using a Phillips screwdriver, unthread the handle screw (#2B) counter-clockwise and remove the handle (#3B).

3. Slide the adapter (#4B) off the assembly.

To replace the cartridge (#5B), see article 1200, 116719 and 162154 Cartridge: Moentrol with Integrated Transfer Valve.

Assembly:

1. Confirm that the cartridge clip is installed and rotate the stem of the cartridge (#5B) so the small notch is facing down.

2. Position the handle adapter (#4B) so the numbers on the front of the handle adapter (#4B) are upright and slide it onto the assembly.

3. With the lever of the handle (#3B) facing down, slide the handle (#3B) onto the handle adapter (#4B) and use a Phillips screwdriver to thread the handle screw (#2B) clockwise until tight.

4. Push the cap (#1B) back into the handle (#3B).  

Note: If after testing you notice the hot and cold are reversed, see article How to Reverse Hot and Cold for a 1225 Cartridge in Shower.